Settings/retrieve xferred call on
From Snom User Wiki
< Settings
- WEB USER INTERFACE
- V8: Advanced - SIP/RTP (Tab) - SIP(Section): Retrieve Transferred Party On
- PHONE USER INTERFACE
- n/a
- FIRMWARE VERSIONS
- V8
- Starting versions: 8.6.7.3, 8.7.3.10
- XML CONFIGURATION
- <retrieve_xferred_call_on perm="PERMISSIONFLAG">VALIDVALUE</retrieve_xferred_call_on>
- DESCRIPTION
- When a call is transferred, the transferred party sends notifications to the tranferring party about the progess of the call towards the transfer target. The notifications include the current SIP response code received by the transferred party. This settings specifies at which point the transferring party will deem the transfer failed and retrieve the transferred call (which up to this point is still on hold). This occurs when the reported SIP response code is equal to or greater than the value of this setting. This setting should be administered in tandem with the setting release_xferred_call_on.
- Note that when marking a call with save transfer the phone will ignore the actuall setting value and instead act as if this was set to 200.
- VALIDVALUE
- any SIP response code in the error code range of 400 and up
- DEFAULTVALUE
- 400
- FURTHER INFORMATION
- Transfer
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > V8 > Setting:V8
Products > IP phones > Snom3x0 > Setting:snom3x0
Products > IP phones > Snom8xx > Setting:snom8xx
Products > SIP conference phone > Snom MeetingPoint > Setting:snom MP
Products > SIP paging > Snom PA1 > Setting:snom PA1