Settings/eth net

From Snom User Wiki

Jump to: navigation, search
WEB USER INTERFACE
V6: Advanced - Ethernet Ports(Section): Net Port
V7: Advanced - Network (Tab) - Ethernet Ports (Section): Net Port
V8: Advanced - Network (Tab) - Ethernet Ports (Section): Net Port
PHONE USER INTERFACE
N/A
FIRMWARE VERSIONS
V6  V7  V8  
XML CONFIGURATION
<eth_net perm="PERMISSIONFLAG">VALIDVALUE</eth_net>
DESCRIPTION
This setting is used to configure the NET port of the phone's integrated Ethernet switch. The setting value is a comma-separated list of three items:
<speed>,<pause>,<advertisement>
Whereas each item has the following meaning:
  • <speed> - setting forced Ethernet speed or enabling auto-negotiation
  • <pause> - enable Ethernet flow control via PAUSE frame (empty value leaves the feature disabled)
  • <advertisement> - space-separated list of properties to advertise (empty advertises all supported properties)
For example, the following setting value would auto-negotiate the Ethernet speed, while leaving the pause feature untouched (empty value between the two commas) and advertising that only 1000MBit and 100MBit full duplex can be auto-negotiated:
auto,,auto 1000full 100full
Note:
The values 1000full and 1000half are only supported by phones with an integrated Gigabit Ethernet switch.
<pause> is not supported for D120
VALIDVALUE
A comma-sparated list with these three items (<pause> and <advertisement> may be left blank):
<speed> - one of the following values:
  • auto
  • 10half
  • 10full
  • 100half
  • 100full
  • 1000full
<pause> - one of the following values:
  • tx_rx_off
  • tx_on
  • rx_on
  • tx_rx_on
<advertising> - a combination of the following values (space-separated):
  • auto
  • 10half
  • 10full
  • 100half
  • 100full
  • 1000full
DEFAULTVALUE
auto
FURTHER INFORMATION
Ethernet
Personal tools
Interoperability