Settings/auto redial value
From Snom User Wiki
< Settings
- WEB USER INTERFACE
- V7: Advanced - Behavior (Tab) - Phone Behavior (Section): Redial After (sec)
- V8: Advanced - Behavior (Tab) - Phone Behavior (Section): Redial After (sec)
- PHONE USER INTERFACE
- N/A
- FIRMWARE VERSIONS
- V7 V8
- XML CONFIGURATION
- <auto_redial_value perm="PERMISSIONFLAG">VALIDVALUE</auto_redial_value>
- DESCRIPTION
- If auto_redial is on, the value of this setting is used to redial the same number in case of busy signal.
- VALIDVALUE
- time (in seconds)
- DEFAULTVALUE
- 10
- FURTHER INFORMATION
- Dialing
Categories: Setting:V7 | Setting:V8 | Setting:snom3x0 | Setting:snom8xx | Setting:snom MP | Setting:Dialing | Setting:snom PA1
Products > Features > Calling features > Dialing
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting > Setting:Dialing
Products > Firmware > V7 > Setting:V7
Products > Firmware > V8 > Setting:V8
Products > IP phones > Snom3x0 > Setting:snom3x0
Products > IP phones > Snom8xx > Setting:snom8xx
Products > SIP conference phone > Snom MeetingPoint > Setting:snom MP
Products > SIP paging > Snom PA1 > Setting:snom PA1