Settings/auto redial
From Snom User Wiki
< Settings
- WEB USER INTERFACE
- V7: Advanced - Behavior (Tab) - Phone Behavior (Section): Automatic Redial On Busy
- V8: Advanced - Behavior (Tab) - Phone Behavior (Section): Automatic Redial On Busy
- PHONE USER INTERFACE
- N/A
- FIRMWARE VERSIONS
- V7 V8
- XML CONFIGURATION
- <auto_redial perm="PERMISSIONFLAG">VALIDVALUE</auto_redial>
- DESCRIPTION
- In case of busy signal the phone will make an automatic attempt to redial the same number if this setting is turned on. The redial time is dependent on the setting auto_redial_value.
- VALIDVALUE
- on
- off
- DEFAULTVALUE
- off
- FURTHER INFORMATION
- Dialing
Categories: Setting:V7 | Setting:V8 | Setting:snom3x0 | Setting:snom8xx | Setting:snom MP | Setting:Dialing | Setting:snom PA1
Products > Features > Calling features > Dialing
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting
Products > Firmware > Setting > Setting:Dialing
Products > Firmware > V7 > Setting:V7
Products > Firmware > V8 > Setting:V8
Products > IP phones > Snom3x0 > Setting:snom3x0
Products > IP phones > Snom8xx > Setting:snom8xx
Products > SIP conference phone > Snom MeetingPoint > Setting:snom MP
Products > SIP paging > Snom PA1 > Setting:snom PA1
